xSahara Kids Electric ATV

Valued up to: $1000.35

$ 556.99 + Free Shipping!

Buy 2 or more at: $536.99 ea.

Instant Check Price: $534.71

 

Now even your littlest enthusiasts can enjoy the thrill of the ride with GoBowen's all-electric xSahara ATV for kids. The tough 350 watt motor is powered by two 12 volt batteries for long-lasting fun. The batteries charge in a few hours and can pull kids up to 165 pounds as fast as 9 miles per hour for approximately 2 hours before needing a recharge. The xSahara comes with several built-in safety features, like disc brakes for strong stopping, a wide, 30 inch wheelbase for better stability and a speed controller that allows parents to limit the ATV to either 7 or 10 miles per hour (approximate). Available in several colors and cool patterns.

Specifications

  • Model: Go-Bowen xSahara
  • Dimension (inches): 44x26x23
  • Seat height (inches): 19
  • Wheelbase (inches): 30
  • Seat to Foot Pedal Distance: 12.5 inches
  • Frame material: high-tensile steel
  • Working front light: Yes
  • Reverse: Yes
  • Motor: 350W (Brush Motor)
  • Max load: 165 lbs.
  • Battery: 24v 12Ah,12V/2pcs (Lead-acid)
  • Drive: chain drive
  • Max speed: 2 settings, 7mph low and 10mph high (approximate)
  • Deck: Acrylic
  • Charge time: 6 to 8 hours
  • Run time: Approximately 2 hours depending on terrain and driver weight
  • Tire size: 4.1-6
  • Brake: Disc
  • Packing Size (inches): 42x24x20
  • Gross Weight: 130lbs
  • Net Weight: 97lbs
  • Warranty: Limited 3 months, 6 months electronics

Support

General Videos

Note: The products shown in these videos may not be identical to the product sold on this page. However, they contain general information that may prove helpful. Viewing them is highly recommended.


Product Documents:

Product Notes:

Warning: The rear axle and motor are held by a metal brace during shipping. Before assembling, this brace needs to be removed and replaced with a shock. Do not let the motor axle assembly slip down further than is needed for shock installation. If dropped too far, the motor wires will pull loose from the motor and the power switch will not work. Once the shocks are installed, the motor will be held in place and no damage will occur.